Approved for:

Cracked and non-cracked concrete C20/25 to C50/60
Also suitable for: Concrete C12/15

For fixing of:

• Steel constructions
• Railings
• Consoles
• Ladders
• Wooden constructions
• Cable trays
• Machines
• Staircases
• Gates
• Facades
• Window elements
• Stand-off installations

• The bonded anchor suitable for cracked concrete consists of the Anchor rod FHB II-A L (long version) or FHB II-A S (short version) and resin capsule FHB II-P, FHB II-PF or Injection mortar FIS HB.
• The FHB II-PF capsules allow quickest curing e.g. 2 min > 20°.
• The capsules FHB II-PF contains quick-setting vinyl ester resin.
• The FIS HB injection mortar is a high-strength 2-component vinyl ester mortar.
• When using the Injection mortar FIS HB 345 S a special application gun is needed. By using the application gun the two components are mixed and activated in the static mixer.
• Partially used cartridges can be reused, simply by changing the static mixer.
• The mortar bonds the entire surface of the anchor rod to the wall of the drilled hole and largely seals the hole.
• Anchor rod FHB II-A A4 made of stainless steel of the corrosion resistance class III e.g. A4 for outdoor use and in damp conditions. Highly corrosion-resistant steel of the corrosion resistance class IV e.g. 1.4529 for applications in aggressive atmospheres (e.g. tunnels, swimming baths).
• Flexible system as both injection cartridge and resin capsule can be used.
• Suitable for use in cracked tensile zone guarantees highest safety.
• Low-expansion force allows cost-efficient fixing with small edge distances and spacings.
• Ergonomic application gun guarantees fast and easy installation.
• Quick installation by hand without a setting tool reduces the work involved.

Advantages/Benefits

Anchor rod FHB II-A L

• Highest loads due to greater anchoring depth.
• Push-through installation by using a push-through element (when using Injection mortar FIS HB).

Anchor rod FHB II-A S

• Reduced anchoring depth for use in thin concrete members, therefore reduced drilling effort.
• Suitable for pre-positioned and push-through installation.

Type of installation

• Pre-positioned installation
• Push-through installation

Installation tips

• For sizes ³ M20, blow out the drilled hole with compressed air (see page X for installation accessories).
• For overhead installation for sizes³ M16 centring wedges are recommended.
• If application is used with FHB II-P capsule, setting tool RA-SDS is recommended.
• Drill hole cleaning according to ETA approval.

Request Data Sheet

Name:
Company Name:
Mobile No.:	A value is required.Invalid format.Minimum number of characters not met.Exceeded maximum number of characters.
EmailID:	A value is required.Invalid format.
Click To Request: